Model 104 Turn Signal Switch

The model 104 turn signal switch provides left and right turn signal momentary switches for 2-inch diameter steering column mounting.  Adapters are available for use with other common diameters. 

The switch uses digital hall-effect sensors to detect the presence of a magnet mounted to the tip of the switch lever. When the magnet is moved close to one of the sensors, battery voltage is produced on the output. When the lever is released, it springs back to the center position and the output returns to 0 volts. Electronics are fully sealed in epoxy providing a tough weatherproof solid-state turn signal switch that can be used in wet locations, including high pressure spray washing, and has an IP68 rating. There are no mechanical switch contacts to wear or corrode. 

The lever knob is removable to allow for a custom knob to match your vehicle design. 

Model 104 outputs cannot provide enough power to drive lights directly.
The model 104 switch must be used with a lights controller.

Installation & Specifications Manual (PDF)

Features

• Sealed hall-effect digital switches
• Suitable for wet locations
• Clamps to 2-inch +/-.03" steering column
• Can be installed without removing the steering wheel
• Billet aluminum enclosure
• Stainless-steel hardware
• Removable lever knob allows for customization
• Wide operating voltage range - can be used on 6V, 12V, and 24V systems